SELF-DAN

Self-adhesive SBS elastomeric, easy peel foil faced tapes.

Product variations:
Waterproofing
Self-adhesive Tape SELF-DAN is a waterproofing bituminous tape, with metallic self-protection (1.2 kg/m²). Composed of a SBS modified bitumen mastic, using as protective material on the upper side of the sheet aluminium foil (60 micron). The anti-adherent material used on the lower side is polyethylene film. Used for small leaks, chimneys, in carpentry, etc.

Scope

  • As damp-proofing and sealing at chimney finishings, pipe joints, parapets, cracks, downpipes, etc.
  • Waterproofing of the joints of sloping skirts with vertical walls.
  • Used for any type of sealing.
  • Sealing of roofs and paving.
  • Sealing of joints and overlaps.
  • Sealing of foor and window frames, eaves, and other roof finishes.
  • Sealing of thermal insulation panels.
  • Sealing of metal and fibre cement panels, under-tile panels, metal roofing, etc.
  • Sealing of the skylight, roof window finishes.

Instruction for Use

Preparation of the substrate:
  • The surface of the base substrate must be resistant, uniform, smooth, clean, dry and free of foreign bodies.
  • The substrates must be clean and dry in order to achieve good adhesion, and it is recommended that they be cleaned beforehand.
    -In the case of porous or not very homogeneous substrates, a bituminous primer (Curidán, Impridán 100, Maxdán or Maxdán Caucho) must be applied before application.
  • In case of not very porous substrates (concrete, metal elements) a previous cleaning of the substrate may be sufficient. However, it is recommended to make a previous test to verify the adhesion.
  • In case it is necessary to adhere on metallic elements or not very porous substrates, previously apply a bituminous primer (Impridán 100) to the whole surface to be adhered.
Application of the film:
  • For ease of installation, it is recommended to cut the rolls into smaller, more manageable dimensions.
  •  Cut the necessary piece of tape to cover the surface to be treated, remove the anti-adhesive layer and apply by pressing hard on the surface. The use of a roller is recommended to apply more pressure on the tape and improve adhesion

Indications and Important Recommendations

  • As with any self-adhesive product, it is important that the surfaces to be glued are as clean as possible.
  • For ease of installation, it is recommended to cut the rolls into smaller, more manageable dimensions.
  • The use of a roller is recommended to apply more pressure on the tape and improve adhesion.

Warning

  • Store in a dry place, protected from rain, sun, high and low temperatures.
  • Before moving the pallet, the condition of the shrink-wrap is checked in order to reinforce it if necessary.
  • Check for possible incompatibility with private waterproofing.
  • Check for possible incompatibility between thermal insulation and waterproofing.
  • The product will be stored in an upright position.
  • The pallets will not be stacked. If high storage is desired, the racks should have beams or braces underneath the wooden pallet.
  • Handle with a crane with a protective net.
  • Do not spray polyurethane foam without first applying a suitable separating layer.

Presentation

  • Length (cm): 100
  • Width (cm): 15
  • Thickness (mm): 1.2
  • Colour: Natural
  • Product code: 205002
SELF-DAN

Technical Data

Concept Value Standard
Mass per unit area (nominal) (kg/m²) 1.2 -
Density (kg/m³) 1000 -
Hazardous substances PND -

Environmental Information

Concept Value Standard
Post-consumer recycled content (%) 35 -
Manufactured in Fontanar - Guadalajara (España) -

Downloads